Refrigeration and heating temperature control system for multiple reactors
1. There are some differences in the quality and configuration of the refrigeration and heating temperature control systems of multiple reactors from different manufacturers. Some equipment will have some noise during operation, and the noise is largely related to mechanical stress.
2. You can check whether the screws on the base of the equipment are normal, whether the force is uniform, and whether they are fixed. If the screws of the unit are loose, use a wrench to tighten the screws of the lower base.
3. The operator has a clear understanding of the operation instructions and maintenance knowledge of the refrigeration and heating temperature control systems of multiple reactors.
4. Do a good job in the maintenance and cleaning of the key components of the refrigeration, heating and temperature control systems of multiple reactors.
5. Protect the key parts of the equipment. If it is easy to get wet, it is necessary to do a good job of anti-layer work.
6. For the heat preservation treatment of the refrigeration and heating temperature control systems of multiple reactors, due to the large number of internal parts, it is necessary to ask technical personnel to operate under the guidance.
7. In order to obtain better treatment effect, enterprises need to choose good thermal insulation materials when completing thermal insulation treatment. Good thermal insulation effect will help to improve the operation effect of the equipment and reduce the failure rate of the equipment.
8. The installation of the circulating pipeline should facilitate the discharge of the gas in the pipeline. If there is leakage, stop the operation in time and use it after repairing; the electric control cabinet should avoid dust accumulation, and should be regularly purged with compressed air to ensure good electrical contact. Always check the contacts of electric heating tubes, fuses, meters, electric contact pressure gauges, and relays.
Our LNEYA dynamic temperature control system SUNDI series, HR series and WTD series can be used for temperature control of reactors, and one or more units can be controlled at the same time. If you have needs in this regard, you can leave us a message and send an email to sales@lneya.com
Recomendações relacionadas
-
Minimum 40 degree refrigerator use precautions
2110The temperature of the lower 40 degree refrigerator is indoor temperature: 5-32 °C, relative humidity 80%/22 °C, the distance from the ground > 10cm, the altitude below 2000m, the safe environment guarantees a smoother operation of the lower 40...
Ver detalhes -
Guia de Seleção para Circuladores de Arrefecimento e Aquecimento de Laboratório
2019When purchasing laboratory cooling and heating circulator equipment, the key point is to meet production requirements and accelerate production output. Therefore, you need to understand the characteristics of the equipment and technical solutions ...
Ver detalhes -
New energy vehicle quality test water cooling chiller simulation equipment
1840It is mainly used in the water cooling system stability test of new products such as electric drives, motors, reducers, and charging piles of new energy vehicles. Constant temperature, constant pressure and constant current heat test (5-85°C), h...
Ver detalhes -
Etapas de manutenção do termóstato de aquecimento e arrefecimento do declive
1838O termóstato de aquecimento e arrefecimento da subida e descida da temperatura da inclinação é o centro para limpar o pó, o lixo, etc. Para limpar e mudar a inspeção, a inspeção pode encontrar problemas, encontrar os potenciais defeitos da subida e descida da temperatura da inclinação alta e baixa...
Ver detalhes
工業冷水機製造商 LNEYA Taiwan











