Suche im gesamten Bahnhof
How to install and debug the electrical of the rapid temperature change test chamber? Need to refer to the following methods for power distribution, pay attention to the capacity of the power supply, do not use a single power supply for multiple e...
Details anzeigen
The ultra-high temperature material impact test chamber test device has too much frozen oil in the evaporator, which can also cause insufficient cooling and cause slow cooling. The oil stored in the evaporator of the ultra-high temperature materia...
Details anzeigen
Produktübersicht:Mikrocomputer-Steuerung, mehrere Sicherheits-Schutz, und zuverlässiger Betrieb; Single-Kompressor automatische Kaskade Unterkühlung Kältetechnik; Kompressoren verwenden Secop und Frankreich Taikang brandContactors und Schaltung br...
Details anzeigen
The high temperature test equipment is mostly caused by water shortage in the water circulation. This way, the purified water is replenished to the water tank until the water level meter on the lower right side of the water tank reaches about 80% ...
Details anzeigen
In the centrifugal small-scale environmental test chamber, the suction recovery device is generally an independent system, and if necessary, the pipeline connected to the condenser and the evaporator can be closed for separate maintenance. After r...
Details anzeigen
Application: 1. The tested object is connected to a test platform adapter. 2. The internal parts of the parts are cooled, heated, flow controlled, and pressure controlled by various lubricating oils, hydraulic oils, aviation fuel, fuel oil, and co...
Details anzeigen
In the pipeline selection of new energy thermal management, if the use of improper/damaged hoses and/or hose joints will result in injury, the new energy thermal management is limited by the temperature, caliber, installation method, etc. Tube, me...
Details anzeigen
Before starting the linear rapid temperature change tester, check whether the relevant protective measures are in place, such as fire protection, protection, leak prevention and other tools. Check whether the power supply is in place according to ...
Details anzeigen
Bei der Auswahl des Schmieröls für das Kühlsystem der Spritzgießmaschine muss auf die Art des Kompressors geachtet werden. Der Kompressor hat drei Arten: Kolben-Typ, Schrauben-Typ und Zentrifugal-Typ. Die ersten beiden Arten von Schmieröl sind ...
Details anzeigen
The failure of the low temperature circulation device frosting is mainly because the compressor return air temperature is too low, which may be that the throttle valve liquid refrigerant supply is in a normal state in the low temperature circulati...
Details anzeigen
工業冷水機製造商 LNEYA Taiwan
